The Joystick for the Largeus tape recorder can be purchased separately and installed on its own. The order number is 2,555,222 15R.
In order to install a new joystick, you will need a box cutter to cut the hole below the joystick hole in the plastic sheeting of the steering column First thing you need to remove the upper and lower part of the helmsman's plating by twisting the two screws at the bottom.
The upper part of the cover needs to be pulled up and the bottom pull down by first opening the height adjustment knob on the steering column. After removing the bottom of the column of the steering column, it is necessary to find the seat for the joystick, it is under the wiper switch.
The following markup should be cut at the bottom of the column of the steering column by cutting the hole for the bow joystick.
The edges of the hole are likely to be irregular. You can solve the problem by installing a rubber sealant.
Now we need to remove the magnet by inserting into the special holes located around the perimeter, nails or spokes of an appropriate diameter.
First, the magnet needs to be drawn on one side, then another.
Once the magnet has been removed, it will be necessary to pull the joystick along the steering column
And get him through a niche to install a magnet.
Now you have to insert the wire wire into the connector on the magnet.
And set it back to its original location. The assembly is in reverse sequence. To secure the joystick, you will need a bolt of nuts with a suitable size.
We close the cover and enjoy the functional of the steering joystick.
