To dismount the colenwala position sensor on Mazda 3 (I), you must: Remove the cover of the JSCB and disable it by undoing the negative wire. Remove the bottom cover for easy access.
- Remove the cover of the JSCB and disconnect it by disconnecting the negative wire.
- Remove the bottom cover for easy access.
- Remove the colenshaft position sensor.
- When installing, make sure that there is no metal shavings that can disrupt the sensor output due to the fluctuation of the magnetic flow.
- Position the colenshaft position sensor and delay from 7.8 to 10.8 Nm.
- Perform further installation in reverse order.