The ignition of the ignition switch in Chord 7 shall be performed in this sequence:
1) Use a screwdriver to disconnect the connectors (it is difficult to remove).
2) Attach a valve to the distributor to collect the spilled oil.
3) Unscrew the three securing screws and remove the allocator.
4) Remove the balancer cover
5) With a Phillips screwdriver, the thumb and protective cover are removed.
6) Record the order of wiring and disconnect them.
(7) Scrolls the ignition switch, the TDC sensor, the switch and the attachment of the metal site.
(8) A screwdriver shall be removed and the finger of its fastening shall be pressed.
(9) Remove the muft and remove the shaft from the site.
(10) Wet sticks and alcohols clean all parts and sensors. Lubricating the bearings.
11) Collects all in reverse sequence.