To adjust the working fluid level at TOYOTOTA LAND CRUISER 200, you must do the following:
(1) Roll out the box cork (bottom crater). If the oil doesn't flow, then you have to finish it.
(2) For models with heated ACPR oil, set the thermostat to the closed position. For this screwdriver it is necessary to press the shaft of the thermostat until it is fixed and fix it with the help of the bar inserted in the side opening.
(3) Roll the filler cap (in the middle of the crankcase) and pour the oil until it begins to flow from the drain. Use the Toyota Genuine ATF WS worker liquid.
(4) Enlock the filler and filler cap.
5) Start the motor and warm the box to the temperature of 38-400.
6) Do not stop the engine, turn off the cork and check the oil level.
7) Wait until the oil begins to flow in a thin stream and twist the cork at 20 Nm.
(8) Enclose the filler cap at 39 Nm.
9) Remove the rod from the thermostat and make sure that the shaft has returned.
