First thing we need to do is remove the seats. To do this, you need to roll two large screws at the front of the floor under the seat and pull the seat back.
There are plastic beings in the rear of the seat sleds, each of which has a carrot. All the smores need to be twisted.
After that, you have to pull an ashtray for the rear passengers. A side of the hinge pin must be removed, the bolted bolt shall be removed and the arm removed.
In an ashtray, you need to twist the two Samores underneath the TORX and lift a part of the tunnel.
Then we need to extract the front ashtray, detach and expose the lever arm of the PPC, pull the frame around the central console pin, and roll out all the smores under and on the climate control block.
There are two smores under the glove box, and they need to be twisted.
Torpedo torpedo needs to remove the triangular plastic panelicles, and they're holding on to the latch.
You also need to remove the front rack lining of the roof.
You have to remove the cover of the fuse box from the left end of the fuse box, circling the rest of the fuses that secure it.
The fuse box needs to be drowned inside the torpedo, the resulting hole should be put on the right hand and the connectors of the light switch connector disconnected. It's better for this unit to squeeze out to make it more comfortable.
Then we need to move to the pedals, spin all the mores from below and take out the pedal mesh with the powderon.
Next, you need to attach a flat-blade screwdriver and remove the diagnostic connector. It's covered.
Then you need to pull the steering lever, put it down and pull it out.
Now you have to press the velvet cloth at the top of the column to detach from the dashboard.
Next, we need to remove the two blank filler panels from the instrument panel with a screwdriver.
Beneath the stub is the carrots that need to be turned off.
After removal of the dashboard, two more Samores will appear, and they must be unwound.
Now you can turn the dashboard and pull it out.
Once the dashboard has been removed, you can see 2 more demoris. One holds the central console and the other holds the lower left side of the torpedo.
Then we need to unroll the remaining perimeters on the perimeter of the torpedo.
Now you can extract the torpedo. We need to be ready for a big weight of a torpedo-about 12 kg.
