This requires the removal of the visor of the instrument panel. It should be understood that the visor is held on four metal clips, and it is necessary to hold the back part of the visor and pull it on. When you remove the visor, you should only pull the visor at the top of the visor. After the visor is disconnected from the instrument panel, it is necessary to retwist the visor by 8 hinges holding the visor. Thus, access to metal clips holding the visor is open.
To eliminate the creaking of the visor, the optimal solution is to use the madeline (the cloth with cloths under protective film). You should cut the size of the raspberries in the necessary size, remove the protective layer, and then tape the problem. It is also possible to use a white cloth plaster, but in this case you will have to do extra work and paint with a black marker of a leukopplet.
Particular attention should be given to the following "problem" locations:
-the fixation of the back of the visor
-to the fixation of the front part of the visor
-points of contact between the visor and the plastic of the instrument panel;
It will not be necessary to put small pieces of madelina and on the visor itself in the area of contact with the wells and in the entire arc, as there is contact with the bottom when installing.
At the end, the white hamster of the visor should be reattached.
The goat should be placed in its nest, and with an effort to fix it. If the visor is correctly locked, no part of the raspberries should be visible from the outside or in the area of the instrument panel.
