The procedure for replacing the regular rear speakers of Lifan Smiley is as follows: We buy new speakers of 97x154 mm. If you take the other, you'll have to install them in the shelves. It's also desirable to buy a copper wire to replace the structure of the aluminum. Let' s connect the wires to the speakers and the back of the mat. We pull out the back of the trunk. We pull out the back of the trunk. We pull the plug on the back of the back. We pull the plug on the new dynamic. We pull the plug on the left side. We pull the plug on the left side. Installation site.
- We buy new speakers of 97x154 mm. If you take others, you will have to install them in a shelf rather than in a normal place.
- It is also desirable to buy copper wire to replace the permanent aluminum.
- Connect the wires to the speakers and isolate the connection.
- Get the back of the rug, the bulkhead, and the shelf.
- Scrolling two samorese, getting two clips and taking off the left side of the trunk.
- Disconnect the speaker connector by pressing the latch.
- Scrolls four of the salines and unwind the normal dynamic.
- Cut the connector and attach the new speaker to the connector.
- With the seal of the glazing, seal the gap between the speaker and the installation site.
- Between the dynamics and the installation site attach a dense, but well-transmitting fabric. It will be necessary to keep the rubbish out of the speaker.
- Keep the speaker on the spot.