If you change the radiator to the VAZ 2108 (2109 or 21099) with all the recommendations, you must first pour the cooling fluid and fully understand the dashboard. However, it is recommended that experienced car owners make the work easier: without dismantling the dashboard and even without the pre-release of antifreeze. The following procedure describes how to replace the heater heat sink with a 2108, 2109, and 21099 radiator with both a low and a high cover. You'll need an assistant to carry out your work. Replacing the heater heater radiator 2109 with a high panel
Replacing the heater heater radiator 2109 with a high panel
1. The thoracic aperator is in the front passenger's legs so that the front passenger seat is better for the work to be carried out.
2. Find and unroll the bolts on the right side of the bolts that attach the bezel.
3. Slightly pull the panel and insert in the resulting slot (wooden brucus of the appropriate size).
4. Close the cranik, attach old rags in places where the leaking of oJ can occur.
5. Open the hood and cover of the expansion bar on the heat sink. To reduce the pressure on the system, close the cover.
The heater is in the area between the glove compartment and the bottom shelf. The next steps need to be done very quickly to prevent the anti-freeze spill. Also, you need two rubber stubs to plug the hoses from the heat sink.
6. Attach one rubber filler, draining the arms through the intended panel to the heat sink.
7. Remove the bottom tube and the left hand with the thumb of the left hand and insert the right hand into the hose assembly.
8. Take the pre-prepared refrigerant fluid, place it under the tube, remove the finger and plunder it.
9. Repeat this operation with the upper pipe.
10. When the coolant fluid is merged, the oven heat sink can be removed and new. When you extract the heater heat sink, you need to lift it up slightly, move it a little, and then pull it down.
Replacing the heater radiator with a 2108, 2109, or 21099 with a low panel
In general terms, the order of action when replacing the oven heat sink to 2109 with a low panel is similar to that for the high panel. The time must be a little less, since it is possible to change the oven radiator without removing the passenger seat. In addition, experienced car owners are advised to remove the rudder so that it is not affected when the panel is bent.
Note that at the end of the works it is necessary to remove the coolant from the hand, as it is dangerous for health! You have to wash your hands and dry your face!