If you are not satisfied with the standard light in the boot of Getz (the small fon on the left with a lamp of 5 W), you can put a 10-W lamp, but it is unlikely to solve the problem. You can make an extra LED light.
The finishing positions are above the pockets on the right and on the left, two on each side. A simple diode build will come up-connect two diodes and a resistor. It is necessary to cut a small fee for two diodes and one side of the dividing lines in the conductive layer on one side. Put the diodes on the heat paste and bring it to the board. Attach the brass "mustache" to the card. Look in the corner of the trunk above the pocket of five holes: four small holes to do a "mustache," and one big hole for wires. We need to remove the sheathing to fix the diodes and draw the wires underneath it. Remove the three screws that secure the center panel on the back of the boot and pull it out. Bring the moustache and the wires to the holes previously made. Dock the light-emitting diode card by curing the copper "whiskers" on the inside, and carry out the wires to the place where the staff plaid is connected. Connect and, before you can collect, make sure that everything is working properly.
