The procedure for removing the climate control block on the fourth generation of the fourth generation: We're taking the decorative panel off. To do this, insert a screwdriver into two special holes on the side of the block. The two bolts are the two bolts, and we remember the location of the bracket that these bolts hold. The tightening of the climate control is the control and the wiring of the cables. The installation is done in reverse sequence.
- We're taking the decorative panel off. To do this, insert a screwdriver into two special holes on the side of the block.
- Scrolling two screws to the hexagon and remember the position of the bolts holding the bolts.
- pull out the climate control block-self-control and disconnect the wires.
- The installation is done in reverse sequence.
