The rear bumper of the first generation of the first generation of Mazda is easier than the front, but the rear lamps will also have to be removed. The entire process takes an average of half an hour.
Tools will require:
- screwdriver
- Passengers
- Key 10
To disassemble, you must do the following:
1. Install the vehicle on the handbrake and lift the rear part.
2. Turn off the battery's minus.
3. Remove the upholstery to access the rear lamps. We need to extract four plastic pitons on the inside of the trunk.
4. Now we need to move the trunk upholstery and unscrew the two nut clips that secure the headlights by 10.
5. Now you need to detach two cartridges and remove the headlamp.
6. In the rear of the wheel arches, there are two screws to twist them.
7. There are two additional plastic screws at the bottom of the bumper.
8. There is a hidden screw under the cover, which also needs to be turned off.
9. The screwdriver needs to extract 2 more plastic pistons
10. In the place where the rear lamps were installed, the screw shall be removed and a plastic pilon be removed.
11. It is now necessary to detach the edge of the bumper at the junction of the wing simply by pulling it onto itself. The same latches are in the middle of the bumper, and they need to be disconnected by pulling the bumper over it.
