The following materials and tools are needed to install the protective mesh before the Kia Sorento 2 heat sink: a protective grid, scissors, and a thermogun ("building dryer"). After the bumper is removed first, you need to try the grid to the grille. After that, you need to bend the grid to the grille edges. Next, you need to preheat the grid, while the grid is in the grate, and then you need to cut off the remaining grid at the end of the grid.
- After the bumper is first removed, the grid is to be attached to the grille.
- After that, you need to bend the grid to the grille edges.
- Then use a thermonuresque to heat the grid to the grille in the bends.
- It's better to get better at the end of the line, and then it's the center.
- Finally, you need to cut off the rest of the grid.
You can also try the grid without dismantling the bumper. This will require a construction pit or a lift. The grid shall be positioned at the bottom and attached to the elements of the body by plastic homutes. It is important that the handles are not in contact with the rubber tubes in the subspace. It is no longer possible to cut the mesh to the patrons.
