Noise from wheel arches is normal when driving a car. However, not every motorist is ready to listen to the hum of rubber, the knock of the stones and sounds from the suspension, so many people decide to make a noise insulation of wheel arches. The procedure is not too complicated, so wheel arches can be made with their hands without the help of specialists. How to Make Wheeled Shoes
How to Make Wheeled Shoes
The complete noise isolation procedure consists of two parts:
- insulating the arches from the inside,
- Exclusion of wheel arches from outside.
Noise isolation of wheel arches from the inside is usually made together with the noise insulation of the entire compartment or luggage compartment. In this case, the sequence of actions is simple:
- Clear and degreasing the surface by preparing it for the materials,
- proclet the surface of the aroside by visitEarth,
- on top of the cover of the absorbing material.
It is important to make sure that both layers are thoroughly glued and smoothing, no air bubbles under them.
Noise isolation for wheel arches from the outside takes a little more time. The process looks like this:
- Unmount the covers, if any.
- Rash, dry, and degreasing the surface of the archway from the inside.
- Sticking off the vagrhempferer layer, on it is the absorbing material.
- The layers of vibration-isolating material should also be covered with a cover from the side adjacent to the arch.
By the way, if you do not have any of the steps on your car, you may want to think about their purchase, as they not only perform a protective function, but also reduce the noise level coming into the cabin from wheel arches.
If you don't want to be pitted with wheel arches, you can use so-called liquid noise insulation. A composition shall be applied to the purified and prepared surface of the arch which combines the properties of the anticore and noise insulation. This method is easier than traditional noise isolation, but the effect is much smaller.