The removal of the bevels on the body of the car is simple, it can be carried out without difficulty with their hands. However, if it is a deep metal to metal, it is necessary not only to eliminate visible traces, but also to protect the surface from the possible rise of rust. As a result, the process of coloring the metal should be considered with special attention. In addition to the ground and paint, the rust converter will need to be removed.
Rust-to-rust converter needs to be dried after application. Transformers based on orthophosphoric acid of hygrophinic acid (absorb moisture) therefore need to be unloaded immediately, transformers on the basis of formaldehyde and formic acid can not be sad at once. The soil is also hygrophiles and acrylic and epoxy-no.
The sequence of actions to be taken when the vehicle body is very deep is as follows: Clear the metal from the loose rust. Process the rust transducer. After drying up to the white-water, we can wash the water. Drain and degreasing the surface. Thin layer of sour soil (transparent), then two more layers "wet" before the appearance of the dye, drying up to total drying. Apply two layers of acrylic soil, drain. Apply two layers of epoxy soil, drain. Skin mound, wash, degreasing, and double layer of enamel. Hire lac if necessary.
- Clear the metal from the loose rust.
- Process the rust transducer.
- After drying up to the white-water, we can wash the water.
- Drain and degreasing the surface.
- Thin layer of sour soil (transparent), then two more layers "wet" before the appearance of the dye, drying up to total drying.
- Apply two layers of acrylic soil, drain.
- Apply two layers of epoxy soil, drain.
- Skin mound, wash, degreasing, and double layer of enamel.
- Hire lac if necessary.