Skoda Yeti steering sensor is located in the steering gear. To remove a Skoda Yeti turn sensor: Unwind the bottom jam and nut. Remove the cover with a rubber hose from the top. Mark the top two screws at the top. Use an extension cord to remove the sensor from the back of the sensor. Use a snail with a snail sensor to remove the ring sensor from the sensor loop. Remove the black top of the ring with a snail. Remove the black ring with the snail.
- Roll the bottom cork and the nut clip.
- Remove the rubber service cap from the top two bolts.
- Mark the location of the parts under the cover.
- Use an extension cord extension to dislodge the reck from the back of the rack.
- Eject the current with the turning point sensor.
- Unmount a snail with a snail, detach four contacts from the sensor.
- Use a screwdriver to gently down the black ring with the latches.
- Then remove the snail ring from the axis.
- Remove the black top of the ring by retaining the three latches.
- After the repair, the mark sensor is installed so that both sides have enough rotations.