- The first thing to do is to open the hood. There are three screws on the corner of the unit, and they need to be turned on.
- The beaner shall be fixed by a small hexagonal bolt to the lamp body through the cable-management arm. This bolt needs to be turned out and the turning signal out and the power connector off.
- The turning-off is another Samorze, and it also needs to be unplugged, then disconnected from the headlight and remove it.
- The lamp shall be removed from the lamp and two rubber fillers should be removed from the rear.
- The glass is latched on seven plastic clips.
- After that, it's better to wash everything inside and dry out.
- If there is a lens in the headlamp, it must also be cleaned.
- Now you can install the new glass and collect everything in reverse sequence.