Two LEDs and a silicone light light are used to highlight the lever arm. We need to look in the gap between the linings and the central tunnel. If there is a silicone light, then you just need to plug it in. To do this, a plastic lining to the PPC must be removed. It will see the two connectors that are needed: the first on the panel, the second on the bottom of the panel. The connectors must be connected. As a result, when the doors are opened, the light of the panel around the PPC's lever will be lit.
If there is no LED feed initially, you can install it yourself.
It is necessary to remove the plastic lining of the tunnel for easy access. To do this, first push the retainer down in the lower right side of the filler, and then click the rest of the tabs.
You can buy LED feed at any radio outlet store. The "negative" contact is added to the "dad" contact, and there is no need to connect to the "plus". Next, we need to taping LED tape to the filler around the CAT lever. The LEDs should be positioned on the right side of the filler to the right side of the filler. The connector connects a "minus" (it is larger) and the plus sign (which is tightly plugged into the connector, the "Dad" contact is not needed). The power connector is installed, and the filler is docplating.