Regardless of the type of LADA Kalina replacement lamp, the rear lamps need to be removed. In the case of a sedan for this:
1. Bend the lid of the special hatch in the inner lining of the boot;
2. Connect the connector at the ends of the wiring on the side of the connector to the connector;
3. Push the seal in the place of the tourniquet out through the body.
4. Remove 3 nut clips: two on both sides of the sealant and one to a little higher (so as not to drop the nuts and washers into the body cavity, it is better to use the key only at the beginning);
5. Pull the lantern outside.
For hatchback and hatchback bodies, the lamp shall be replaced in the same manner, but the lamp shall be held by only 2 nuts. The upper door is opened when the filler is removed from the top of the safety-belt anchorage, and the lower one is located behind the belt reel. The wiring harnesses may not be disconnected, but the lamp will have to be replaced by the lamp from the outside.
