In the parks, the wipers do not work when they click on the bleach, and they have only two modes of operation-fast and very fast. To avoid damaging the factory transaction, you must purchase a wire with the terminals of 6.5 mm. -5est and a 3.5 mm slot. -5 shi, 3.5-mm. -5s, programmable relay 54.3777-1 unit, and the M8-bolt-1x-1stl, 5mm diameter thermocourious tubes. and 3mm.
Next, remove the cover of the steering column (5 bolts) and detach the connector from the wiper switch. In the tip of the adhesive, 9 is empty. Remove the green wire from the pad (the first wiper speed) of the pad No6 and connect it through the prepared interposer (3.5 mm). in the green-black cable 6.5 mm on the relay) in the contact relay of S. contact J connect to contact of pad 6 (first position of windshield wiper), to the place of green-black wire through the interposer (socket 3.5 mm. -3.5 mm socket. Contact 31 relays as any metal bolt, either mass or "-" (receptacle 6.5 mm). to the steering column of the steering column). Contact 31 in the relay (a parking light switch, zero position of the windshield wipers, the windshield wipers return to the original position), the blue wire contact No5 (remove the wire, reconnect through the 3.5 mm plug). to the blue wire, the 3.5 mm slot. in contact No5, instead of a blue wire, 6.5 mm socket to contact 31 in the relay). Contact 86 relays (windshield washer)-red-yellow wire contact 1 (pull out the wire, attach a 3.5 mm glass converter). A red-yellow wire, a nest of 3.5 mm. in contact No1 instead of the red-yellow wire, the socket is 6.5 mm for the contact of 86 relays. Contact 15 relays of + 12V (front glass cleaner) brown wire line #7 (pull out wire, connect through a 3.5 mm plug). to the brown wire, the 3.5 mm socket to the contact No7 instead of the brown wire, the socket 6.5 mm for the contact 15 relays.
Make sure that everything works in the correct sequence:
1. When pressed on a glass washer less than 1 second, the caretaker is activated twice, the longer the press-the longer the work of the caretaker.
2. The first position (which was rapid) was the standard operating mode-one in three seconds. It can be programmed from continuous to pause in 45 seconds.
Then carefully isolate the connected interposers and pin the relay on the bottom of the steering column. For continuous operation, first position must be included and immediately off when the wipers are moving. Once the wipers return to their original position, they will immediately be placed in the first position. This will work continuously. To change the pause, switch the switch from the first position to "off", hold the desired pause, and re-enable the first position. A new pause between the makh is set.