To start the Toyota Prius engine from a third-party source, a "cigarette lighter" and a second vehicle with a 12-volt ACB are required. You need to open the hood and cover of the fuse box, and then remove the special slot cover to run from the outside of the CCM. Then we need to connect the connecting wires: the "plush" wire is red. It is then necessary to dock one end of the cable at the negative pole of the launcher and connect the second end of the cable to the "land" of the Prius requiring the charge. the wires need to be removed from the sequence, the reverse of the installation sequence.
- You need to open the hood and cover of the fuse box, and then remove the special slot cover to run from the outside of the CCM.
- Then we need to connect the connecting wires: the "plush" wire is red. You must connect it first.
- After that, one end of the cable at the negative pole of the launcher and connect the second end of the cable to the "ground" of Prius for charging.
- After that, it is necessary to start the car engine of the donor and keep it idling for 5 minutes.
- The "POWER" radio button must be put in "ACCESSORY" mode and, supporting engine speed on the donor vehicle, turn the "POWER" switch to "ON" mode and start the hybrid system.
- Ready indicator "READY" should be turned on.
- After you start the hybrid system, you must remove the wires in the sequence, the reverse of the installation sequence.
