Select your language

Installing the buttons on the handlebar is not a very complicated procedure. The following spare parts are required for the dorestyles: Audio control and audio controls (number 4400A401) Audio control unit (number 8701A087) cruise control unit (number 8602A008)

  • Cruise control and audio controls (number 4400A401)
  • Audio control unit (number 8701A087)
  • Cruise Control Unit (number 8602A008)

Part numbers for the ASX retraction:

  • 8602A070-Cruise Control Unit
  • 8616A026-Audio CD control block
  • 8616A027-Audio control unit with T
  • MB435457-MCP vehicle chaining sensor

A transaction can only be used with 4400A401 (doorway with doorway), because the retraction transaction does not have a number for the order and is delivered with the handlebar assembly.

For starboard, you need to remove the steering wheel: rotate it to the left by 90 degrees and unbuckle the clip on the end of the steering column, turn to the right and do the same on the other side. On the other side of the steering wheel it is necessary to unroll one carrion-they hold the spokes in the matches where the buttons will be.

Then it is necessary to rotate the two bolts that secure the airbag. They are on the left and right in the steering column, behind the wheel. The bottom black wire must be disconnected from the pillow. If you disconnect the yellow, you will receive a airbag error that you want to reset in the service. The pillow can now be put aside. Then, you need to turn off the wiring that is located near the center nut of the wheel. Then you will need to unscrew the four rear wheel-assembly attachment screws and the central nut retaining the handlebar. The rudder can then be removed.

Now we need to remove the wiring from the back plate of the rudder and set up a new transaction so that the white coat is on top, blue on the right, the board on the left, the black and the purple one-the bottom, and the orange is hidden. Then you can dock the steering nut with an effort of 44 Nm, connect the wiring starboard, and secure the three screws at the rear of the rudder. The lower left rotor must be fitted with a purple wire and only after that it has been turned on. A black shteker with a purple wire is installed on the lower cell of the airbag. Now you can install the pillow and bolt the bolts. The left handlebars on the left must be the board contact and the right blue on the right. The left side connects and pins the audio control buttons and the control-control unit on the right. Now we can tighten the bolts of the airbag anchorage and start a new function in the service.

Add comment