It's not that hard to install a parkron. The ideal height for installing sensors is 50-55 cm above the ground. For the correct orientation of the sensors to the bumper, a paint tape shall be applied.
First you have to pull out the plastic pallet of the trunk, pulling it up. Below the pan are two holes, closed by silver adhesive labels. What's left, you have to push it-it's designed for a parking meter transaction. Next, you need to drill holes in the sensors. The cut is in the set of parktroics. Each sensor is labeled and must be installed in its place. The orientation of the sensors is also indicated by arrows. The side sensors are better placed on the painted part of the bumper. The wires from the sensors should be skipped into the hole that was covered with a silver adhesive. Control unit can be secured under the trunk lining. Then you need to drag in the passenger seat to the front door, where the white wire with gray circles (plus) and the thick black (minus) are to be found in the wiring. You need to reach out to the dashboard and install it at a convenient location.
