- Before you start, you must turn off the ignition and remove the minus one.
- Then we need to open the hood and find the cover on the headlight.
- The screws on the cover should be rotated counterclockwise, then the cover is removed.
- The cover will be exposed to passing and driving lamps. The lamp on the outside is the passing beam, and the lamp is on the inside.
- The lamp, together with the lamp, must be pulled in a counterclockwise direction, and pull it, the knot will be removed.
- Just to pull the lamp out of the ammo, just pull it out.
- The main thing is not to push too hard on the bulb, or it can burst.
- Then, disconnect the main-beam lamp from the electrical connector by pressing the finger on the connector to the rear of the connector and pulling the lamp up.
- You can now install a new lamp.
In order to replace the passing lamp, remove the electrical outlet from the lamp by pulling it back, pull out the sealing cover, remove the spring, and turn the restraining lamp and remove the lamp. The new lamp must be installed in reverse order.
