The throttle control is part of the intake system, which is responsible for the correct formation of the fuel-air mixture. In the process of operation on the surface of the throttle, the dust and the smallest particles of the motor oil are beginning to pour. Due to the pollution, throttle control stops opening or closing, causing problems in engine operation. The output of one-throttle shall be cleaned from time to time. How to determine that the throttle-hole needs cleaning
How to determine that the throttle-hole needs cleaning
There may be many signs of throttle contamination. Here are some of the main symptoms that suggest that the throttle forced to clean: the car is not well turned (not from the first time), the idling speed is swirling, the engine stalls or moves at idle speed, at a small speed, the car is tangy or moving.
- the car isn't going well (not the first time),
- (a) shall be used for idling speed;
- The engine stalls or is moving at idle speed,
- at a small speed, the car is ptugging or twitting.
Experienced motorists advise you to clean the throttle every 30,000 kilometers. Cleaning the throttle properly
Cleaning the throttle properly
You can clean the throttle with your hands. To do this, you will need the following tools: screwdrivers for the removal of the throttle, wand, old toothbrush.
- -a screwdriver to remove the throttle,
- wands,
- an old toothbrush.
In addition, a special cleaning material-an aerosol which can be purchased at any auto shop-will be needed to clean the throttle.
The easiest thing to do is clean the throttle, remove the throttle (if you clear the shale without removing the node, the efficiency of the procedure will be small). For each car, the procedure for removing the throttle is yours, so we need to start looking at the instructions for a particular car.
The purge is performed using the old toothbrush (the main part) and vite sticks (all canals and cavities). You should remove all contamination from the surface of the throttle using a cleaner aerosol.
Note that on some vehicles the hulled molybdenum layer is covered with a thin layer of molybdenum, which improves the intake system-it is not to be confused with pollution and to remove it.
It is also recommended to remove the idle governor from the dusher to clear the place of its landing.
To extend and clean the ventilation ducts of crankcase gases, you can use a conventional foot pump (the diameter of the connection is similar).
If you have not previously cleaned the throttle, you will need to replace the throttle with the throttle.
In the case of an electronic throttle, a throttle training procedure shall be carried out after cleaning to regulate the stability of idle.
Note that not any problem with the engine can be solved by cleaning the throttle. If visual inspection does not see oil bloom or incoherence, then the throttle cleaning will not bring results.
