1. The first thing to do is to shut down the engine.
  2. Then it is necessary to unwrap the "hybrid" cooling loop cover, remove the cork and drain the cooling liquid.
  3. Now we need to pour one and a half liters of fresh coolant into the expansion tank.
  4. Take the prepared tubes and put them on the plasters, which are located close to the inventor, and drop them into the expandable tank.
  5. After that, you need to spin the connections and continue to pour the coolant.
  6. After that, you need to spin the plaster and the cork of the expansion bachet, turn on the car, and watch the anti-freeze level in the expansion box.
  7. Now you have to squeeze the tube that goes to the expansion bar, and the gel will start to get air bubbles.
  8. The tubes need to be kept in a tight condition until the bubbles are not stopped.
  9. Then we need to finish the liquid up to the maximum level, if necessary



Add comment

Security code
Refresh