The engine oil shall be replaced by the hot part of the engine, all work is recommended to be carried out after 5 to 7 minutes after engine stop.
The oil replacement procedure is as follows:
1. Remove the filler cap;
2. Remove the cover of the oil filter, remove the waste filter element;
3. Remove the cork from the engine crankcase;
4. Oil oil;
5. Install the filler cap;
6. Install a new filter element filter element, close the cover;
7. Fill the new oil through the throat, close the cover;
8. Start the engine, in 5 to 7 minutes, shut down and check the oil level, if necessary, to finish the oil.
For a D20DT diesel engine and a petrol engine with a volume of 2.3 litres of G23D, the recommended oil is 7.5 litres. More than 8.5 litres of oil will be used in a more rare diesel engine, and the capacity of 3,2-litre petrol is approximately 9 litres.
It is recommended that the cork be drawn with a load of 25 +/-2.5 Nm by means of a load cork with an effort of 25 +/-2.5 Nm.