To check the radial pattern of the Jackass to Mazda 3 (I): Place the sections of a calibrated plastic wire on the top of the neck, placing them along the axis. Set up the cap and the cap. replace piston, reciprocating piston, reciprocating ring and shatun assembly to ensure clearance: normal clearance-0.14-0.36 mm; maximum gap-0.435 mm.
- Place the sections of a calibrated plastic wire on the top of the neck of the neck along the axis.
- Set the cap bearing and the Jackass lid.
- Then remove the cap.
- Measure the radial pattern of the Jackass.
- If the gap is not matched, replace the sedimmed bearing or shuffleth the neck of the cap and install the bearings larger to ensure a gap: normal clearance 0.026-0.026-0.052 mm, maximum gap-0.10 mm.
- To check the lateral clearance, install the case of the cap and measure the lateral clearance of the lower head.
- If the clearance is not correct, replace the piston, reciprocating finger, reciprocating ring and shatoon in the assembly to enable the clearance: the normal clearance is 0.14-0.36 mm; the maximum clearance is 0.435 mm.