The brake pedal adjustment procedure on Lifan Solano is as follows: Pull the driver's floor mat down. It shall be 136 to 146 mm.
- Pull out the driver's floor mat.
- I'm the height of the brake pedal from the floor. It shall be 136 to 146 mm.
- If the height does not match the nominal value, disconnect the connector from the stop lamps.
- Take off the stop-signal switch.
- The backrest of the stack and rotate the push rod until we adjust the pedal height.
- We tighten the table nut at 26 Nm.
- Put the stop-signal switch back on.
- We press the pedal about 5 to 15 mm and turn the switch so that the stop lights go out.
- tightening the stop-cage nut of the stop lamps.