To replace the Cylinder capacity of the head of the Lifan Solano cylinder, the following will be required: To remove the pressure in the fuel system. Disconnect the engine oil from the battery. Release the engine oil. Release the coolant. Release the exhaust. Release the coil. Disconnect from the coolant temperature sensor. Detach two screws of the water-amplifier belt. Remove the power-support from the engine.
- Reset the pressure in the fuel system.
- Detach the minute wire of the battery.
- The engine oil.
- Liquid coolant.
- Prom the exhaust manifold and the intake manifold.
- Take off the ignition.
- Remove the generator.
- Disconnect the wire from the coolant temperature sensor.
- Scroll the oil-level guide probe.
- Remove two screws from the water-amplifier belt.
- Disconnect the cooling system from the HC.
- Remove the right foot of the engine.
- Remove the EMG belt.
- Take off the rampart.
- BCD screw bolts by 1/3 rotation in this order
- Remove the HBCD and replace the laying and bolts.
- tighten bolts from this order
- It is difficult to implement in three stages-first drag 29 NM moment, then trust 900, then trust 900 again.
- Set it all back, pour oil and coolant.