If Lifan Smiley has stopped working, first check the condition of the electrical connectors and contacts, and make sure that the battery is properly charged. If there are no problems, we need to remove the starter and check it. To do this: We unplug the nut and disconnect the wire from the retractor relay. We unplug the two nuts and pull the retractor off the retractor. Detach the plunger and remove the plunger cap. And remove the cap and anchor. And off the starter, the vintage mug and the gears. We get a steel ball with a magnetized needle. We pull out the outer diameter of the rotor's manifold. It shall not be less than 29 mm (for models 1.2 and 1.4 kW) and 34 mm (for model 2 kW).
- Unwind the nut and disconnect the wire from the starter retractor.
- Unwind two nuts and take off the retractor.
- Unplug the plunger and remove the cover from the plunger.
- Shooter and anchor.
- We're taking off the starter, his next-year mug, and the gears. A steel ball with a magnetized needle.
- We're taking off the alkalis.
- Meriah is the outer diameter of the rotor's manifold. It shall not be less than 29 mm (for models 1.2 and 1.4 kW) and 34 mm (for model 2 kW).
- I'm dead to the bottom of the reservoir. It shall not be less than 0.2 mm.
- Check the circuit between the plate and the toothbrush. It must be open-whipping.
- Check the rotations of the gears-it shall be easily clockwise and counterclockwise when the rotation is counterclockwise.
- Checking for the height of the brush. It shall not be less than 10 mm (for models 1.2 and 1.4 kW) and 9 mm (for model 2 kW).
