The V6 Infiniti FX35 engine is located on the right and on the left, 3 on each side. The first thing to do is to remove the plastic cover of the engine. To get to the candlelight on the right-hand side (if facing the bonnet), the duct must be removed from the air duct to remove the throttle, close to the throttle, and the clamps near the air filter, disconnect the mass flow sensor of the mass air flow sensor.
Now we need to disconnect the electric spark plugs, screw the bolt, screw the coil and pull them out.
Now you can spin the old candles and gently spin the new candles.
The candles on the left are more difficult to replace, since there are many wires and pipes.
Two small air hoses should be removed. One is located in the front of the engine and the second is in the rear.
Behind the far pipe is a vacuum. It is fixed by two screws to the engine. They need to be twisted and pushed back with the arm of the arm. Then we also need to dismantle the ignition coils as well as on the right side. The process is complicated by the wiring harness that lies on the top. It needs to be pushed aside. The room is a little bit, but it's enough. After the candles are replaced in the left side, the assembly is reassembled in reverse order.
