It will require the most die-fitting modules that are suitable for the Kia Cerato 2 mirrors. Also, a crst screwdriver, a key for 10, and an outcast will be required.
First of all, we need to remove the mirror itself. It's from the salon. It is necessary to find a screwdriver of the high frequency dynamics located in the passenger compartment opposite the rearview mirror. It's holding on to the latch. Then, disconnect all slots and roll the 3 screws holding the mirror. If you unwind the last bolt, you must keep the bolt as it does not fall to the ground.
Now you need to remove the mirror from the mirror. To do this, it needs to be hooked up and redrawn. After it is disconnected from the mirror, you need to disconnect the heating connectors. Now we need to disconnect the mirror itself from the platform to which it is attached by means of a leak. It's enough to heat this mirror. In the same way, the heating plate is removed. Then, remove the exterior cover of the mirror, it is located on the two latches. The undismounted mirror shall be the retaining screw of the repeater signal repeater located on the exterior of the mirror. It needs to be turned out and the repeater and wire removed. The cables should be connected to the new additional repeater (black and red wire-"plus", black-"minus").
You can then gather everything in reverse order. When installing, remember that the mirror will lose the part of the heating (at the repeater site).
