The procedure for replacing the site block is as follows:
(1) Wheel the wheel in the right direction.
(2) Remove the vehicle by removing the protective cover of the lower leg of the shock absorber.
3) If the bolts of the attachment lever are lubricating the penetrating lubricant.
4) Loans and lower bolts of the lever.
(5) The back beam shall be tulked and the bolts are completely unbolted.
6) Remove the lever.
(7) Press the old clip. To do this, you can use the vice and the appropriate desolation or the old bearings.
8) A new site has been put in place. For ease of reference, it is possible to lubricate the thick lubricant of the lithol.
9) Enclose the site.
(10) Put it all in place. The bolts of the lever need to be filled first, then remove the crates from under the beam and roll it.
