To replace the rear connector with Honda Civil 8: Remove the rear of the car and place the emphasis. Remove the rear wheel. Right and left side of the stabilizer on the right and left side of the stabilizer. Remove the voltage regulator assembly. Remove the stabilizer bushing and stabilizer bracket. It is important not to confuse the right and left side of the stabilizer on the transverse stability. You need to review the replacement/installation section of the stabilizer to connect the stabilizer to the drive. Check the wheel installation angles and adjust them if necessary. If necessary, return the flange bolts and the stabilizer bracket.
- Lift the rear of the car and set the focus.
- Remove the rear wheel.
- To detach the stabilizer on the right side and the right side of the stabilizer on the right side of the stabilizer.
- Remove the bushing and stabilizer on the side of the stabilizer and remove the stabilizer bracket and the rack stabilizer.
- Install the transverse stability stabilizer in reverse order.
- When installing, it is important not to confuse the right side and left side of the lateral stability stabilizer.
- Align the labels on the transverse stability stabilizer with the end of the tulles.
- You should also familiarize yourself with the replacement/installation section of the stabilizer in order to connect the transverse stability stabilizer with the traction.
- Inspects the wheel installation angles and adjust them if necessary.
- Also, if necessary, exit the flange bolts and the stabilizer bracket.
