Replacement of liquid at the EGUR at the Citroen C4

To replace the liquid in the electrohydraulic drive, the rudder (hereafter referred to as the EGUR), shall: Set up a Citroen C4 on a lift. Disconnect the reverse hose assembly. Set up the capacity to drain the old liquid. You can turn the car around and rotate the steering wheel several times until it stops. It can be replaced with a screw.Start the engine. Adjust the level: rotate the steering wheel a few times "right-to-left"-the level of the liquid will be reduced, the air will be released.

1. Install Citroen C4 on the lift.
2. Disconnect the duct hose, cut the handle.
3. Get the old liquid drain.
4. Start the car and turn the steering wheel several times "right to the left" until the liquid ceases to flow.
5. You can replace the "outerhead" with the "screw" and replace it with the screw.
6. Fill the liquid with the probe (about 500 grams).
7. Make an engine.
8. Adjust the level: rotate the rudder several times "right-to-left"-the level of the liquid will decrease, the air will be released.
9. Lift the fluid and rotate the steering wheel until the level is stable.

Add comment