Vehicle interior

Details

Written by: Jason Hance

Also available:

Created: 08 August 2022

To remove the sheathing at the back of the ASX, it is necessary to remove the rear seat. The pillow can be removed by taking the edge and pulling it up. Then, it is necessary to reposition the back and rotate the four clip-nuts

Details

Written by: Jason Hance

Also available:

Created: 07 August 2022

The most likely cause of the creak is the unclanging latch of the ducts (more than 10). To remove the violin, remove the cover from the duct and verify all the latches

Details

Written by: Jason Hance

Also available:

Created: 05 August 2022

It is often possible to hear tapping on the right front side of the vehicle when roughing up the roughness at Mitsubishi ASX. The reason for the sound-shock absorber of the glove, ensuring its smooth opening. This shock absorber at the roughness is beating against the wall of the glove

Details

Written by: Jason Hance

Also available:

Created: 04 August 2022

Mitsubishi Outlander can be installed at Mitsubishi Outlander (code 7200B249HA (gray) or 7200B249YA (beige)). It is necessary to cut the opening of the complex shape above the interior of the passenger compartment

Details

Written by: Jason Hance

Also available:

Created: 02 August 2022

It is very simple to install a rear view camera because it has a space for it. You only need a hole with a hole in the camera. It is also possible to make an opening

Details

Written by: Jason Hance

Also available:

Created: 01 August 2022

For the installation of the cooling and heating system, the glove compartment at Mitsubishi ASX will require two parts-tube and valve. The first line is to remove the glove compartment by first removing the left hand delimiter and then the delimiter and the shock absorber with the right

Details

Written by: Jason Hance

Also available:

Created: 30 July 2022

The gleam of the glove at Mitsubishi ASX is not too bright due to the use of a very small, low-powered lamp, so it can be replaced by LED feed

Details

Written by: Jason Hance

Also available:

Created: 29 July 2022

A similar problem is encountered at Mitsubishi ASX and Mitsubishi Lancer of the tenth generation. The cause of the buzzer is the elevator in the guides of the elevator

Details

Written by: Jason Hance

Also available:

Created: 27 July 2022

It is possible to replace the air conditioner with climate control, but this work should be trusted by professionals, as the number of changes is very serious, and the knowledge and experience is needed. The climate control components can be used by the tenth generation Mitsubishi Lancer

Details

Written by: Jason Hance

Also available:

Created: 26 July 2022

Most ASX owners have similar problems. The smell is usually exacerbated in the raw weather. The reason is the specific oil in the variator. The smell is particularly noticeable in new cars and, in time, is often lost