Vehicle interior

Details

Written by: Jason Hance

Also available:

Created: 10 July 2022

Most Lancers of the ninth generation have a regular light-on. You can replace it with a similar, but with built-in overnight. It's a factory spare, its number is MR794300. It will be necessary to cut part of the ceiling plating

Details

Written by: Jason Hance

Also available:

Created: 08 July 2022

In order to install the chiller system, the master will need the following original spare parts: 7830A145-duct-tube; 8006A087-shale; MB409437-screw.

Details

Written by: Jason Hance

Also available:

Created: 07 July 2022

It is often possible to hear tapping on the right front side of the vehicle when roaming the unevenness in Lancer X. The reason for the sound is the glove compartment of the micro-lift. To eliminate the sound underneath it, you need to get a piece of it

Details

Written by: Jason Hance

Also available:

Created: 06 July 2022

The water enters the passenger compartment through a filler between the left front wheel archway and the passenger compartment. The filler has an opening through which the bonnet cable passes through

Details

Written by: Jason Hance

Also available:

Created: 04 July 2022

Most likely, it is condensation formed during the process of air conditioning. The water pipe has a moisture radiator from the air conditioner to the machine. The tube is located between the engine shield and the engine

Details

Written by: Jason Hance

Also available:

Created: 03 July 2022

To replace an ashtray lamp in lancer, first of all, we need to get the ashtray itself out. To get her out, you have to open it up and pull it up. An ashtray is a light bulb to be removed and replaced with a new light. After that, you can install an ashtray

Details

Written by: Jason Hance

Also available:

Created: 01 July 2022

The ninth generation Laser Filter is located behind the bar. To replace him, you have to open the glove box. There is a tab in the upper left corner of the bar to extract. The retainer is not removed

Details

Written by: Jason Hance

Also available:

Created: 30 June 2022

First we need to open the glove compartment and disconnect the microlift from the glove compartment by pulling it sideway. After that, you put pressure on the top side of the glove box and pull it on you, it'll come out.

Details

Written by: Jason Hance

Also available:

Created: 28 June 2022

Mitsubisi Outlander XL has two crates. In the bottom light, it works when the exterior lights are turned on. There's no one in the top glove box.

Details

Written by: Jason Hance

Also available:

Created: 27 June 2022

No special place under the first aid kit and a fire extinguisher in XL. The small size kit is placed in the pocket (right arch in the boot). The fire extinguisher (2 l) is not easy to accommodate. You can drive it in an amateur bag. A lot of drivers take him in the trunk.