In the first place, a door opening filler is removed-it needs to be mounted on top of something sharp. Then the panel from the door handle is removed from the top and bottom, and pull it hard. It is necessary to remove the block of buttons by pulling off the edges and detach all wires.
From the bottom, you need to pull the whole thing off the surface of the plating, pushing out the paistons. Then, you need to lift the panel up and pull it on you.
To remove the entire panel, disconnect the cable from the door handle. To do this, you need the latch to pull upward and release it, and then remove the rope with the ball at the end from the interior door opening handle
A part of the pistons after the removal of the plating will remain in the door-they need to be hooked and inserted into the holes in the plating.
