Many of the "trackers" almost immediately after the purchase of the air conditioner fan. Sometimes during the launch, sometimes all the time. The fan is located on the left side, if you stand facing the bonnet. You can replace the fan with the unoriginal (about 1,500 roubles), but you can try it and fix it. The first case to the left of the fan is to disconnect the power terminals and unscrew the three screws that secure it at the base of the heat sink, and remove the screw. To do this, you need to unroll the central nut clip. Then we need to unscrew the three screws on the side of the fan. Now you need a flat-blade screwdriver to back off the back cover of the motor and remove the cover. Inside, you can see the wrapping and the springs. Also, it's likely to be rust and dirt. Everything needs to be sorted out, cleaned with silicon grease, dry dry and dry. Special attention should be paid to the magnets as there is dirt on them.
- The first case to the left of the fan is to turn off the power cell and unscrew the three screws that secure it at the base of the heat sink.
- Then remove the screw. To do this, you need to unroll the central nut clip. Then you need to unwind the fan assembly that is attached to the three screws.
- Now you need a flat-blade screwdriver to back off the back cover of the motor and remove the cover. Inside, you can see the wrapping and the springs. Also, it's likely to be rust and dirt. Everything needs to be sorted out, cleaned with silicon grease, dry dry and dry. Special attention should be paid to magnets, as there is dirt on them.
- The bearings and the centre of the cover should be put in thick grease.
- Now we need to insert the linchins under the brush and set the bristles back, and wrap the projecting wire around the base of each brush so that they do not get out during the installation.
- Then you need to insert the rotor between the brush and free the hinges.
- Then a quick movement must put the top cover on the rotor so that the rotor does not get out of the brushes.
