To remove the wheel cap on Skoda Yeti you need to: Install the wheel key in the wheel assembly, insert the wheel key into the wheel, and bolt the wheel and disconnect the cap from the disc. also when installing additional caps to ensure that sufficient air flow is provided to cool the braking system.
- Install the bracket from the onboard tool onto the reinforced edge of the wheel cap.
- Then, insert the wheel key in the bracket, lock the wheel and disconnect the disc cap.
- When installing the cap, combine the cap with the opening of the tyre valve and drown the wheel with the hand of the wheel on the disc, recording it from all directions.
- Attention: Cops can damage the rail and center elements of the shell.
- Before installing the shell on a steel disc, fasten by means of a bolt-top, make sure that the bolt-secret bolt is spinning in the hole located in the ventil area.
- Also, if additional caps are installed, ensure sufficient air flow to cool the braking system.
