It requires a pad, a jack, a balloon, a 14, a big screwdriver, or a slit, silicone grease.
You must do the following:
- Scroll the cover of the brake fluid (located in the upper right corner of the subspace).
- Unmount the wheel. The wheel is located on two fingers of the brake. The upper one needs to be twisted completely, and the bottom unscrew is not the end.
- Drop the sup, put a pin in the kill or the screwdriver, or the screwdriver.
- Scroll down the bottom "finger" and remove the old pads.
- Tap out the outer part of the new lubricant pad that comes with the pad. That's the same lubricant to "fingers." Install new pads.
- Apply the brake dry port to the place, twist fingers, wear a wheel, close the lid of the brake fluid.
- Press the brake pedal several times until it becomes solid.
