The back brake pads on Citroen C4 are recommended to change only in the complex on both wheels. Remove the back wheel, put the back wheel at the front, and remove the back-wheel. Remove the nut from the inside of the bottom of the pad, which is able to catch up to the end of the pad. Extract the foot pads on the outside of the sub-port. Remove the "pimp" pad. Extract the old brake pads from the bottom surface of the guides. to wipe them out with petrol and dry off. Pull out the foot pads. Then set up the new pads and the back of the pan. You can put your finger on the pad and put it back on it, but you don't have to tighten it. You want to put on the pad and tighten the nut. Repeat the procedure for the second wheel. And then you can squeeze the foot brake down a few times, to adjust the contact with the brake discs. You can wheel the wheels and drop the car from the jack. Check the hydraulic fluid level.
- Raise the rear wheel of the jack wheel, place the front wheel, and remove the rear wheel.
- To solidified a nut from the inside of a subport that had to be made up to the end of the pad.
- Eject the security pad.
- Retrieve the finger of a pad from the outer side of the subport.
- Remove the "verse" spring.
- Fetch old brake pads with linings from the sub-port.
- Remove contaminations from the surface of the guides, wipe them with petrol and leak.
- Fetch a finger and remove the old pads.
- Next, install new pads and "anti-horn" spring.
- You tighten your finger tie-down and put the fastening clip on it, but don't drag it out yet.
- Set up the pad security and tighten the nut clip.
- Repeat the procedure for the second wheel.
- A few times to squeeze the foot brake to adjust the contact with the brake discs.
- Wheels up and down the car from the jack.
- Check hydraulic fluid level.
