Replacing the front brake pads on Audi 100 C4

To change the front brake pads at the Audi 100, you need to: Remove the wheel bolt and remove the brake disc screw. Disconnect the connector from the wear bracket and remove it from the carrier arm. Remove the locking spring of the outer pad. Remove the external pad. Remove the brake disc and the inside of the wheel. Use the spurp to crush the rivets. connect the connector to the connector. Install the internal drive. Install the disc. Set the external pad. Set the locking spring. Press the brake pedal to complete the installation of the pad.

1. Cease the car and remove the wheel.
2. Detach the brake disc attachment bolt.
3. Detach the connector from the wear bracket and remove it from the bracket.
4. Remove the locking spring of the outer pad.
5. Remove the outer pad.
6. Remove the brake disc and the inner pad.
7. With the help of the inkscuring to crush the port of the seaport.
8. Clean the installation area of the pad, lubricate the guides of the sub-port with the special grease.
9. Install a new wear sensor, attach a connector to it.
10. Set the internal deck.
11. Install the disk drive.
12. Set the outer pad.
13. Set the locking spring.
14. Press the brake pedal to complete the installation of the pad.

Add comment