Replacement of ABS sensors on Audi 100 C4

Replacement procedure for ABS Astudio 100 4th generation: Ruping the car and removing the wheel. From the side of the body, find the ABS sensor to remove the lower cover of the sensor. Detach the connector and remove the sensor.

1. Lift the car and take the wheel off.
2. On the side of the body, find the ABS sensor.
3. Pull off the bottom cover of the motor to disconnect the sensor from the sensor.
4. Disconnect the connector and remove the sensor.
5. Before installing the fixation tuner, fill in the lubricant oil hole in the bearing body.
6. Presse the stick and push the sensor with the hand to the point.

Add comment