Car body

Setting thresholds (or threshold protection) based on the design of the thresholds themselves

If there are no reels in the car picking, then eight holes will be required to install them (each Wraith is located on four bolts). The installation takes place on the roof of the car, it is necessary to completely remove the ceiling plating

The ancient and creaking of the sheathing in the trunk arises from the contact of rigid plastic panels. The easiest way to solve the problem is by adhesive docking panels with "anti-spam" material

The rear retro-reflectors are mounted on the bumper by means of two screws. It is possible to remove and install reflectors without dismantling the bumper, which requires a short Phillips screwdriver. The most convenient is to do this on the pit

The installation of the car is suitable for the original patchwork of the spray-sprays as well as the sprayproof of the third parties, including the universal. The montage of the spraygoers is carried out on the carrots in the number of three to five pieces

The car is equipped with crankcase protection, but it is not reliable enough, so it makes sense to install steel protection. It is not difficult to install as it is normally fastening to the normal orifice in the body and chassis

Suzuki Grand Vitara II will need the following tools: two screwdrivers and a wide nail file. Carefully lift the casing of the mirror, snorting it with a file. Slightly warm the mirror with a hair dryer and drop the mirror to the bottom of the mirror.

In order to remove the front bumper Suzuki Swift II, three screws are required to be removed: two front fog lamps and one centre. At the top, under the eyelets, unscrew the carrots, and with the screwdriver to roll up and remove the pistons, three on each side

To remove a side mirror or a mirror with an electrostatic setting on Suzuki Swift II, you first need to remove the plastic lining of the two stacks of the attachment. Replay the three door retention screws and gently pull out the mirror

If the wiper blade on Suzuki Swift II begins to break, it may be necessary to remove the entire movable part of the windshield wiper. To do this, remove the rubber cap and unscrew the Gull of the wiper blade