The front bumper for BMW 1 of the second generation shall be removed from this sequence: We turn all the mores down from the bottom of the bumper and pull out two plates. Let' s roll the steering wheel to the left wheel. We get the right wheel to the right wheel. We're going to get the left wheel on the right side of the wheel. We open up the left wheel archway. Under it, the BRAC key unwind (but not to the end) all the cut-edge self-cutts. disconnect the electro-connectors and the washer hoses. You can wrap the upper screws and make the bumper forward. By installing the bumper in reverse sequence.
- Scrolling all the mores down the bottom of the bumper and pulling out two clips.
- Start the car and turn the steering wheel to the left.
- Scour the sour on the right wheel archway.
- Just a little bit off the bumper, and we're going to get another one on the top.
- Repeat the procedure for the left wheel arch.
- Open the hood and remove the rubber profile.
- Under that key, the BRAC will unwind (but not the end) all upper anchorages.
- Carefully unplug the bumper from each side, disconnect the electrical connectors and washer hoses.
- Surrender the top screws and make the bumper forward.
- Install the bumper in reverse sequence.
