To run the self-diagnosis mode, you need to stop the engine, remove the feet from the pedals, switch the ignition switch to the "ON" position, wait 3 seconds and 5 times press and release the gas pedal. After 7-10 seconds, you must press the gas pedal and wait for the blinking of the Check Engine lamp to start. As soon as the light bulb starts to blink, you have to let go. Blinking of a light bulb means to switch to self-diagnosis.
To clear all errors, press the gas pedal and hold it for a few seconds before starting the engine. It is important to remember that fault reset can not resolve problems. After the engine starts, the errors are likely to appear again.
- 1000 CAN Link
- 0102, 0103, 1102-Air mass flow sensor
- 0112, 0113-Intake air temperature sensor
- 0117, 0118-WF temperature sensor
- 0120-throttle position sensor
- 0121-accelerator position sensor
- 0327, 0328-detonation sensor
- 0335-Rotation shaft angle sensor (POS)
- 0340-Location Sensor (PHASE)
- 0500-Car speed sensor
- 0605-ECM module
- 0705-Location switch of the Parking-Neutral (PNP) switch
- 0706-PNP switch
- 0031, 0032-Oxygen sensor 1
- 0037, 0038-Oxygen sensor 2 (not our case)
- 0031, 0032-Oxygen sensor 1
- 0132, 0133, 0134, 1143, 1144-Heated oxygen meter 1
- 0138, 0139, 1146, 1147-Heated oxygen sensor 2
- 0444, 0445-Elektron flushing of EVAP carbon filter
- 0550 = Hydroamplifier oil pump pressure sensor
- 0650-Check indicator
- 0710-0725, 0740-0755, 1705, 1760-Probes and electrical valves associated with the NPP
- 0165-ESM power supply source
- 1111-Electrical valves of inlet valves phases
- 1122, 1123-Electronic throttle control
- 1212-ESP/ABS block communication channel
- 1805-Stop lamp switch
- 0011-Installation of the distribution of inlet valves
- 0171, 0172-Work of the fuel injection system
- 0300-0304-Ignition Ignition
- 0420-Work of the three-way catalyst
- 0731-0734-The work of the NPP
- 1121-throttle electric drive
- 1217. Engine overheating (OVERHEAT)
