The clearance check of the Lifan Smiley gas distribution mechanism shall be carried out as follows: Disconnect the connector 1 and connector 2.Disconnect the oil pressure sensor connector 3.H on the cover of the HBO by exposing the electrical wiring 4.
- Disconnect Slot 1 and Generator 2.
- Disconnect the oil pressure sensor connector 3.
- On the HBB cover, release the electrical wiring 4.
- Remove the transaction from the cylinder head cover.
- Disconnect the crankcase ventilation ducts from the cover of the HBCD.
- With four nut clips removed the cover of the GBV with a gasket removed.
- Put the piston of the first cylinder at the top.
- Check that the label on the pulle1 is the same as the anchor label.
- I'll use the probe to check the valves 1, 2, and 3.
- The nominal values for the intake valves are 0.2 ... 25 mm and for the prom 0.25 ...
- Writes the received values.
- We're turning a 360-degree knee.
- Check to make sure that the cap on the wheel alignment coincides with the mark on the GRM-belt panel.
- I'm the one with the valve gaps 2, 3, and 4.
- Writes the received values.
