The scrub of the throttle may well be performed on its own. Only a flat-blade screwdriver and an asterisk are required from the tools. It will also require an injector purifier or fuel system cleaner, sponge and soft cloth, which does not leave a sparrow.
First, you need to unroll an air filter. It is held by two hamts at the beginning and at the end. We need to unscrew the screws to remove it. You can then unscrew the four thumbscrews that hold the throttle housing.
Next, there are two options: simpler and more complicated.
A more complicated option is to turn off the sensor located on the throttle and wash it off. A more simple option is to not disconnect the wires, move the throttle, as far as possible, and wash the liquid so that it does not fall on the engine.
The washing process itself is not complicated. We need to put the injector purifier on the shale, wait a little bit for the sunburn, and wash the dishes for a few times. After the flushing, you need to wipe the cloth with a soft cloth. When washing, pay special attention to the shale axis and to the end of the shale itself. After the flushing, it is necessary to check whether wet patches, wormwood or pieces of sponge are left in the damp.
