The release and inspection of the exhaust manifold shall be carried out in the following order:
(1) A protective cover of the exhaust manifold shall be removed.
2) Teach the bolts and remove the collector from the HC.
(3) Padding of the manifold.
(4) Check the collector for cracks and other damage. If it is possible, then the surface shall be measured not more than 0.3 mm.
(5) Install the manifold. The moment of tightening of the bolts is M8-25-30 Nm, M10-35-55 Nm. The layout needs to be replaced by a new one.
